MasterCraft 054-8251-6, Инструкция по эксплуатации

Страница: 6 / 13

CORDED MULTI-CRAFTER KIT - 054-8251-6 CORDED MULTI-CRAFTER KIT - 054-8251-6
9 10
On/Off switch
(fig 1)
1. Connect the power cord of your multi-crafter to
a standard household power outlet.
WARNING!
Always ensure that the switch is on the
OFF position before you plug the tool
into a power supply. Failure to do this could result in
accidental starting and cause serious injury.
2. To turn the tool ON, push the on/off switch forward.
3. To turn the tool OFF, pull the on/off switch backward.
Variable-speed dial
(fig 2)
The variable-speed feature on this multi-crafter
allows you to match the proper speed to the
material being cut, sawed, scraped or sanded,
enhancing the overall performance of your tool
and helping to save the application tool from
undue wear.
1. The variable-speed dial is used to adjust the
speed of the application tool.
2. Turn the dial to increase or decrease the speed
of the tool (fig 2).
3. Position “1” selects the slowest speed; position “6” selects the fastest speed. Adjust the speed for
optimum performance.
NOTICE:
Determine the optimum speed by making a trial cut in a scrap piece of material.
Know your tool
1
5 6
3
4
2
No. Description No. Description
1 On/Off Switch 4 Ribs
2 Variable-speed Dial 5 Flange Bolt
3 Drive Shaft 6 Adaptor for fitting DREMEL ®
accessories
Before attempting to use this tool, become familiar with all of its operating features and safety
requirements. For optimum performance and safety, read the following operating instructions carefully
before using.
WARNING!
Do not allow familiarity with the multi-crafter to cause a lack of alertness. A fraction of a
second of carelessness is enough to cause severe injury.
OPERA
TING INSTR
UCTIONS
DESCRIPTION
fig 1
Variable-
speed
dial
5
6
fig 2