MasterCraft 054-7121-2, Инструкция по эксплуатации

Страница: 6 / 14

20V max* LITHIUM-ION CORDLESS ANGLE GRINDER- 054-7121-2 20V max* LITHIUM-ION CORDLESS ANGLE GRINDER- 054-7121-2
9 10
ADDITIONAl SAFETy INSTRUCTIONS FOR GRINDING OPERATIONS
• Use only wheel types that are recommended for your power tool and the specific guard
designed for the selected wheel.
Wheels for which the power tool was not designed cannot be
adequately guarded and are unsafe.
• The guard must be securely attached to the power tool and positioned for maximum
safety, so the least amount of wheel is exposed towards the operator. The guard helps to
protect the operator from broken wheel fragments, accidental contact with wheel and sparks that
could ignite clothing.
• Wheels must be used only for recommended applications. For example: do not grind with
the side of cut-off wheel. Abrasive cut-off wheels are intended for peripheral grinding, side forces
applied to these wheels may cause them to shatter.
• Always use undamaged wheel flanges that are of the correct size and shape for your
selected wheel.
Proper wheel flanges support the wheel, thus reducing the possibility of wheel
breakage. Flanges for cut-off wheels may be different from grinding wheel flanges.
• Do not use worn down wheels from larger power tools.
A wheel intended for larger power tool
is not suitable for the higher speed of a smaller tool and may burst.
Contents:
Cordless angle grinder, side handle, wrench, 4 1/2" grinding wheel and instruction manual.
WARNING!
Remove the cordless angle grinder from the package and examine it carefully. Do not
discard the carton or any packaging material until all parts have been examined.
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................... Volts
A ..................... Amperes
Hz ................... Hertz
W .................... Watts
min ................. Minutes
............... Alternating current
............. Direct current
n
0
................... No-load speed
............... Class II Construction
…/min ........... Revolutions per minute
............... Grounding terminal
BPM ............... Beats per minute
.............. WARNING – To reduce the risk of injury, user must read instruction manual .
Further safety instructions for operation
KICKBACK AND RElATED WARNINGS
• Maintain a firm grip on the power tool and position your body and arm to allow you to
resist kickback forces. Always use an auxiliary handle, if provided, for maximum control
over kickback or torque reaction during start-up.
The operator can control torque reactions or
kickback forces, if proper precautions are taken.
• Never place your hand near the rotating accessory. The accessory may kickback over your hand.
• Do not position your body in the area where the power tool will move if kickback occurs.
Kickback will propel the tool in the direction opposite to the wheel’s movement at the point of snagging.
• Use special care when working corners, sharp edges etc. Avoid bouncing and snagging
the accessory.
Corners, sharp edges or bouncing have a tendency to snag the rotating accessory
and cause loss of control or kickback.
• Do not attach a saw chain woodcarving blade or toothed saw blade.
Such blades create
frequent kickback and loss of control.
SAFETY GUIDELINES SAFETY GUIDELINES