MasterCraft 054-3182-0, Инструкция по эксплуатации

Страница: 6 / 11

CORDED IMPACT WRENCH - 054-3182-0 CORDED IMPACT WRENCH - 054-3182-0
9 10
Installing and removing the
socket
(fig 1)
WARNING!
Always verify that the tool is switched
off and unplugged before installing
any accessories on the tool.
Always use the correct size socket for bolts and
nuts. An incorrect socket will result in inaccurate
and inconsistent fastening torque and/or damage
to the bolt or nut.
1. To install the socket, push it onto the output drive of the tool until it locks into place.
2. To remove the socket, simply pull it off.
Turning the impact wrench on
(fig 2)
1. Connect the power cord of your impact
wrench to a standard household power outlet.
2. Press the part of the switch marked “F” to run
the tool in the forward direction (clockwise
rotation). Use this direction for tightening bolts
or nuts.
3. Press the part of the switch marked “R” to
reverse the motor direction (counter-clockwise rotation). Use this direction for loosening bolts or
nuts.
4. Release the switch to stop the tool.
5. Keep the switch pressed for continuous operation.
Know your tool
1
2
No. Description No. Description
1 1/2” Square Drive 2 Forward/Reverse Switch
Before attempting to use this tool, become familiar with all of its operating features and safety
requirements. For optimum performance and safety, read the following operating instructions carefully
before using.
WARNING!
Do not allow familiarity with the impact wrench to cause a lack of alertness. A fraction of a
second of carelessness is enough to cause severe injury.
DESCRIPTION
OPERA
TING INSTR
UCTIONS
fig 2
Switch
fig 1
Socket
Output drive