CHANGING THE DOOR-OPENING DIRECTION:
TOOLS REQUIRED:
A Phillips screwdriver.
5
BEFORE SWITCHING THE REFRIGERATOR ON:
Clean the inside with warm water and bicarbonate of soda. Rinse and dry
carefully.
Wait for 2 hours before starting, to ensure that the motor lubricants have
stabilised.
If the refrigerator has been switched off, wait 4 hours after restarting before
placing food inside.
PROCEDURE:
1. Unplug the refrigerator and take everything from
the compartment.
2. Remove the cover from the top hinge. (Fig.1)
3. Unscrew the top hinge screws. (Fig.1)
4. Take the door off with an upward movement.
5. Remove the panel using putting it in places marked
A- itsupper part. Pull up the panel by rotating a screwdriver
7. Remove the cover of the central hinge screws, and unscrew the two screws
holding it in place (Fig.3).
10. Change the position of the bottom hinge shaft,
placing it on the opposite side (Fig.3).
11. If fitted, change the lateral handles to the other side.
12. Reverse this procedure to refit the doors.
Fig. 2 Central hinge
Fig. 3 Bottom hinge
A screwdriver.
8. Move the freezer door upward to releasse.
till latches open. Then lever the down part of the down part
of the panel up (3 rectangular extrudes) and take the panel off.
9. Then, remove the screws and take lower hinge
off (Fig.3).
ENGLISH
Fig. 1 Top hinge
6. Make a hole for upper hinge by cutting the special part B (left side of the panel)
(Fig.2).
Содержание LCE-818NF
