12
•
Adjust the hob connections: these are
located underneath the knobs
(Fig. 04)
.
—
Proceed one tap at a time.
—
Remove the knobs and the gaskets by
pulling them up.
- Switching from natural gas to
butane/propane (depending on model)
-
Using a small flat-head screwdriver, screw in
the brass burner-power screws (yellow) all the
way,
(Fig. 05)
screwing them in a clockwise
direction.
-
Replace the gaskets and the knobs, paying
careful attention to their direction and
ensuring that the knobs are pushed in all the
way.
- Switching from butane/propane to natural
gas (depending on model)
-
Unscrew the brass (yellow) burner power
screws
(Fig. 06)
, using a small flat-head
screwdriver, turn twice counterclockwise.
-
Replace the knob.
-
Light the burner in maximum heat mode,
then turn down to reduced heat mode.
-
Remove the knob again, then turn the
burner power screw clockwise until it reaches
the lowest possible setting that does not
extinguish the flame.
-
Replace the gasket and knob.
-
Make several attempts to change from the
maximum flow rate to the minimum: the flame
should not go out ; if it does, unscrew the
burner-power screw so as to obtain good
flame retention during these position
switches.
-
Reposition the burner heads, burner covers
and pan supports on the hob.
Fig. 05
Tap axis
Burner power
adjustment screw
Fig. 06
Tap axis
Burner power
adjustment screw
Knob
Base
Gasket
Tap
Fig. 04
EN
2 / INSTALLING YOUR APPLIANCE
Содержание GCF32SI
Страница 1: ...EN USER MANUAL PL INSTRUKCJA INSTALACJI I OBS UGI Cookinghob P yta grzejna GCF32SI...
Страница 37: ...37...
Страница 38: ...38...
Страница 39: ...39...