Mastercook 2MIE-4GLS B, Инструкция по эксплуатации и техническому обслуживанию

Страница: 21 / 44

INSTALLATION
UK
6
4. Place the hob in the middle of the cut-out and push it so that the seal adheres tight to the worktop.
5. Fix the hob with the four brackets which are included together with other connecting parts (Fig. 9 and
10).
6. After installing the hob, the horizontal partition "
A
" may be placed under the worktop which will
protect the user against accidental touching of a hot hob from the bottom.
Fig. 9 Fig. 10
2.2 CONNECTING THE HOB TO THE NATURAL GAS SUPPLY
Attention
!
1. The hob must be connected to the gas system according to relevant regulations
and by an authorised gas fitter.
2. Before installation, make sure that the shut-off cock is closed.

This hob is designed for gas and pressure indicated on the rating plate. The hob is equipped with an
elbow and seal (Fig. 11).

Connection to the internal gas system should be either rigid or with a flexible metal pipe.

Gas supply is ended with a shut-off cock. The shut-off cock should be easily accessible after
installing the hob in the worktop.
Fig. 11
2.3 CONNECTING THE HOB TO THE LIQUID GAS BOTTLE

The hob may be converted for use with liquid gas. For this purpose nozzles in burners have to be
replaced and knobs have to be adjusted.

If this hob is intended for use with gas bottles, it should not be installed in a cellar or any other
compartment with a floor below ground level as the liquid gas is heavier than air and accumulates at
the floor level.

When connecting the hob to the gas bottle, use a certified rubber hose.

Each time the gas bottle is connected, check the tightness of the valve on the gas bottle and the
connection and operation of the reducer.
rear brackets
bracket
worktop
gas hob
Bottom of the hob
front brackets