NTP100 – Rev 1.0.1 Dec-04
15
© Masterclock
®
, Inc.
A password can be a maximum of 11 characters and may contain any sequence of letters, numbers, and common
punctuation. Passwords are case-sensitive.
WARNING: If the password is lost, the user must reset the NTP100 using the Reset button on the rear of the
unit. This will cause the unit to return all configuration to factory-default settings.
To remove a password, select the Set Password command. You will be prompted to enter the old password. Do not
enter anything into the New Password or Confirm Password fields. Click OK to save, or Cancel to leave the old
password unchanged.
When a password is set for an NTP100, each time you attempt to perform a configuration change you will be asked for
the password. You may enable the
‘Remember this password for the session’
checkbox to eliminate typing the
password for each configuration change. WinDiscovery will not remember the password after it is closed so maintain
passwords in a safe place.
[Note: each device listed can have a unique password associated with it, which will default to the factory default
password. You must enable the “Remember this password for the session’ checkbox for each device that is being
configured.]
Once a password has been memorized for a device, a “Forget memorized password” option is added to the right click
drop down menu for that unit.
[Note: the factory default password is: public]
Set Time/Date
The Set Time menu item lets you manually set the time and date for the NTP100. The function may be most useful for
demonstration, in lab situations, environments where an external signal is not available. The time for the NTP100 can
either be set to the time of the PC or a manual custom time can be entered.
