1
GB
SAFETY INFORMATION
MAIN COMPONENTS
REMOVAL OF THE HEATER FROM THE PACKAGE
OPERATION
SAFETY INFORMATION
!!! IMPORTANT: carefully read all the Operator's
Manual before assembling, starting or performing
maintenance operations on the heater. The heater
may cause severe accidents due to burns, fires or
electric discharges.
This heater is portable and is designed for indoor
heating of areas like warehouses, shops and homes.
The heater is compliant with the requirements of
Standard EN 60335-2-30.
•
Do not cover the Heater while in operation.
•
Never install the heater in rooms containing
gasoline, solvents, paints or other highly
inflammable materials or close to curtains.
•
Keep the heater away from children and
pets.
•
Verify that the supply voltage and frequency
are compliant with the data specified on the
nameplate.
•
Always use three-wire grounded extensions
with an adequate section.
•
Disconnect the heater from the mains when it
is not in use.
•
The heater should not be positioned
immediately below a socket.
•
Only use the original handle to shift the
heater from a place to another.
•
Before leaving the heater unattended, make
sure it cannot be used and always
disconnect it from the mains.
•
Never use the heater with programmers,
timers or other devices that could
automatically start it, as fires could break out
if the heater is not covered or located in a
correct position.
•
Never use the heater next to bathtubs,
showers or swimming pools.
•
Always disconnect the heater from the mains
by pulling the plug out of the wall socket
before servicing, cleaning or repairing the
heater.
•
Never perform maintenance operations when
the heater is hot or running.
MAIN COMPONENTS
See Page 2
1)Protection grille, 2)Foot, 3)On/Off switches,
4)Power cable, 5)Cable tie, 6)Parabola, 7)Lamp,
8)Cover, 9) Closing panel.
REMOVAL OF THE HEATER
FROM THE PACKAGE
•
Remove all the packaging materials used for
transportation purposes.
•
Remove all the items from the boxes.
•
If the heater appears to be damaged, report
the damage to the retailer from which it has
been purchased.
OPERATION
!!! WARNING: carefully read the warnings listed
in section Safety Information in this manual and
follow them carefully to operate the heater in full
safety.
Verify that the power cable is not damaged.
Damaged power cables must be replaced by the
manufacturer or by its technical service or, at any
rate, by a qualified technician trained to prevent all
possible risks. Verify that the technical specifications
of the socket comply with those listed in the
instructions or shown on the nameplate of the heater.
Do not use the heater without mounting all the
accessories the support stand.
STARTING THE HEATER
The power output can be adjusted at three ratings
(See pag.2). Turn switch 1 to ON for 1/3 rating
(800W). Turn switch 2 to ON for 2/3 rating (1600W).
Turn both switches ON for maximum rating (2400W).
TURNING THE HEATER OFF
Move both switches to position 0 and disconnect the
heater from the mains. Wait a few minutes to allow it
to cool down.
Содержание TS 3 AI
Страница 1: ...4165 219 Edition 10 Rev 3...
