06.3 «AUTOMATIC HOOKS» MODE
ON
Go to point 4
Return to point 2
3x
Prog
06
NOTE:
If the learning procedure has been carried out with the hooks disengaged, remember to insert the hooks and try to carry out
a hooking maneuver to verify the correct functioning of the system.
CAUTION:
During normal operation, the motor may go slightly below the automatically set lower limit switch to facilitate the insertion of
the hooks.
1-
Connect the power supply.
2-
Press PROG briefly (within 1 minute).
The motor makes a signal
3-
Press briefly UP.
If the motor moves downward return to point 2,
if the motor moves upward go to point 4.
4-
Bring the drop awning in an intermediate position,
keeping pressed UP or DOWN.
5-
Press STOP briefly 3 times and wait.
The motor starts to make briefly upward movements...
6-
After the
press briefly STOP.
FIRST MOVEMENT
The motor moves downward...
7-
The motor (
) stops automatically when terminal
bar reaches the lower limit; otherwise press STOP to stop the motor in
the desired position.
if mount with offset adapter
If you want to adjust the position more precisely, see the
"Fine
adjustment of the limit switches"
box, otherwise wait about 10 s.
8-
The motor moves upward. If the installation has a mechanical stop
(recommended), go to step 9, otherwise go to step 10.
9-
Upper limit switch by "pressure" (recommended):
wait for the terminal to rest against the stop.
Motor makes a short downward movement. Installation completed !!
10-
Manual upper limit switch:
press STOP to stop the motor in the desired position.
If you want to adjust the position more precisely, see the
"Fine
adjustment of the limit switches"
box, otherwise wait about 10 s.
The motor makes a signal. Installation completed !!
only if the offset
adapter is NOT
mounted
Prog
Prog
Press PROG briefly, press UP or DOWN to move the motor
step-by-step, once you have reached the exact position,
press PROG briefly.
Fine adjustment of the limit switches