OPERATION
6
BATTERY PACK
!
WARNING:
1.
2.
3.
The battery is not fully charged. efore first use, the battery pack requires 5-7 hours charging time
to be fully charged. Subsequent recharging needs 3-5 hours for the battery to be fully charged.
Always switch to a fresh battery when tool performance begins to diminish. Severe heat is most
destructive to a battery; the more heat generated,
.
the faster the battery loses power A
that gets too hot can have a
battery
shortened life.
Never over-discharge a battery by using the tool even after tool performance has decreased.
Do not attempt to discharge a tool ’s battery by continuing to
pull on the tool trigger. When tool
performance begins to diminish, stop the
tool and recharge the battery for optimal performance.
5.
6.
Always have drill rotation switch in neutral/lock position when removing or
inserting battery to avoid unintentional starting.
To remove battery pack from the tool, press the lock spring buttons and pull
out.
To insert, simply push pack in until lock spring clicks.
The battery charger consists of two parts:
A. a switching adapter
B. a charging stand
To recharge battery, connnect the switching adapter/plug low-voltage lead to
the charging stand.
1.
2.
3.
4.
The green light is the charge indicator. When the charger is connected to AC
household current, the green light is on
(Fig.1).
The green light is the power indicator. When the battery is properly inserted into
the charger and charging, the red light is on.
Normal charging time is 3 to 5 hours. The charger will charge the battery at the
normal rate until charging is complete. The red light will turn off once charging is
complete. After the battery is fully charged according to the charging time provided
in the instructions, remove the battery pack from the charging stand immediately.
Battery temperature will cool to normal.
When charging more than one battery pack, allow 15 minutes between
charges.
After many charge/discharge cycles, your battery will lose its ability to hold
a charge. It should then be replaced. Dispose of batteries at an appropriate
waste disposal facility. Do not throw batteries away in common trash receptacles.
Insert the switching adapter/plug into a correct household current receptacle.
The end of the battery pack has positive and negative terminal markings on
it. Align these with the identical markings on the top of the charging stand and
insert pack into base. (Pack will not insert properly if rever
s
ed)
7.
8.
9.
10.
11.
12.
13.
WARNING:
REMEMBER:
When the machine is obstructed, please turn off the switch right away
This tool is cordless and does not need to be connected to a power
supply.
and check if the work piece is right. An obstruction may cause the
machine motor to be burned.
CAUTION:
Do ot expose either the elect
tool or charger to the rain or water.
Do not overcharge the battery as this could damage the battery's cells.
Do not force the tool. If the tool is stalling, it is possible that the battery
power is low. If so, stop working and recharge the battery pack.
To prolong the life of the tool, do not continually for work more than 20
minutes at a time.
!
!
!
Fig.3
Fig.2
Fig.1
A
Green
light
Red light
B
Содержание MW110D
Страница 11: ......
