Master Spas TS 240, Руководство пользователя

Страница: 35 / 84

33 DO NOT DIVE.
REGULAR MAINTENANCE PROCEDURES
Note: These are areas that will require the spa owner to perform routine maintenance. These are not
areas covered under the warranty of the spa.
CLEANING JETS
The majority of jets in your spa can individually be turned on/off. If any
of these jets become hard to turn, it will be necessary to remove the jet
to clean it as grit/sand and mineral deposit may be present.
The jets in your spa can be removed for cleaning by unscrewing them
(counter clockwise) and then pulling out the jet.
To Clean Jets
Place the jet(s) in a container, fully immerse in white vinegar. Let the jet(s) soak overnight and then
rinse with water. Reinstall the jet(s). It may be necessary to clean grit and deposits from the white
jet body (mounted in the spa shell) by using a small bristled brush.
CARE OF LAMINAR FLOW JETS:
In order to keep your Laminar Flow Jets operating properly, follow these instructions in sequence:
- Turn off Laminar Flow Jets
- Remove outer ring by turning face counter clockwise
- Remove internal Jet insert with a pair of needle nose pliers
- Clean plastic filter at the back of the Jet insert so all holes are free of debris
- Reinstall Jet insert and outer ring
CLEANING DIVERTER VALVES
Due to mineral deposits and grit/sand that may get into the internal parts of the diverter valve, it
may become hard to turn or freeze up completely. Excessive force applied to turn the valves can
cause unwarranted damage to the valve. In this case, it is necessary to remove the handle and cap
of the diverter valve. Before proceeding, make sure the power to the spa is turned off.
Turn the cap piece counter clockwise. It may be necessary to put a clean cloth over the cap and
turn it with a wrench.
Once loose, the cap and handle can be pulled up out of the white plumbing fitting.
Wipe down the internal piece that attaches to the cap and handle.
Soak the cap and handle in white vinegar.
The white plumbing fitting should also be wiped down. If the surface of the white plumbing has
become too abrasive, you can take wet, fine sandpaper and smooth it out. It is also helpful to use
a lubricant (use silicone based, not petroleum based) to allow for an easier turn of the diverter
handle.
Rinse the diverter internals and reassemble.
In the future, it is helpful to turn the diverter valve only when the pump is not on. Cleaning your
diverter valve should occur every time you drain your spa.