Master Spas legacy whirlpool, Руководство пользователя

Страница: 25 / 64

23 DO NOT DIVE. 100 DO NOT DIVE.
Step 1:
Your spa should be filled using a Pre-filter, which can be obtained from your local
dealer. This Pre-filter will help remove many of the minerals existing in the water,
which will make adjusting the water balance easier after a new fill. Never use more
then 50% softened water when filling the spa.
Step 2: During the initial filling of the spa, add a sequestering agent to combat suspended
minerals in the water. The agents are sold under many different names such as Mineral
Clear or Metal Protect. Allow water to circulate and filter for at least 30 minutes
(or per bottle recommendations) before adding any other chemicals.
Step 3:
Test water for pH, total Alkalinity, and Calcium hardness. The pH should be 7.4 - 7.6
and the total Alkalinity 100 - 120 ppm. Calcium hardness levels should be maintained
between 150 and 250 ppm (part per million).
Step 4: Adjust pH and total Alkalinity (TA) utilizing the directions on the chemical bottles.
Wait 15 minutes, test and adjust if necessary.
Step 5:
It may be necessary to retest and add additional chemicals to get to the proper levels
in Step 3.
Step 6: Add concentrated chlorinating granules * (sodium Dichlor-s-triazinetreone) to reach a
Free Chlorine level of 5 to 8 ppm on initial start up to begin sanitizing the spa water.
Bathers should not enter the spa until the chlorine levels drop below 5.0 ppm. Always
refer to the chemical manufactures dosage recommendations listed on the container.
It is important not to add the chlorinating granules until the pH, alkalinity and calcium
hardness have been adjusted to their proper levels.
*SPECIAL NOTE:
We recommend a minimum level of 2.0 ppm residual free chlorine be maintained in spa water. Always refer to
the chemical manufacturer’s dosage recommendations listed on the container.
When adding chlorine or non-chlorine shock/oxidizer always broadcast across the water while the pumps are
running.
The quantities of sanitizer and oxidizer shown in this manual are for 500 gallon spas and may have to be adjust-
ed depending on the actual amount of water that your spa holds. See the specifications section of this manual
for the correct gallons of your spa.
The concentration of active ingredients in spa chemicals varies by manufacturer. The amounts of sanitizer sug-
gested in this manual are based on spa chemicals that have the active ingredient percentages listed below:
Chlorine Non-Chlorine Shock/ Oxidizer
Active ingredient: Active ingredient:
Sodium dichlor ................................. 99% Potassium peroxymonosulfate ....................... 42.8%
Other ingredients ................................ 1% Inert ingredients ............................................ 57.2%
Total ............................................... 100% Total............................................................ 100%
WATER MAINTENANCE – START-UP