50
DO NOT DIVE.
50
DO NOT DIVE.
100
DO NOT DIVE.
INITIAL START-UP
When your spa is first turned on, it will go into Priming mode, indicated by “Pr”. During Priming
Mode, press
Jets
button(s) repeatedly and be sure all pumps are free of air. Priming Mode lasts less
than 5 minutes. Press
Temp
to exit. After Priming Mode, the spa will run in Standard Mode (see
Mode section).
The pump responsible for heating and filtration (Pump 1 low-speed on non-circulation system, or
the circulation pump on circulation systems) will be referred to simply as the pump. In multi-button
sequences, if the buttons are pressed too quickly in sequence, they may not register.
TEMP CONTROL (80°F - 104°F / 26°C - 40°C)
The last measured water temperature is constantly displayed when in standard mode. The water
temperature displayed is current only when the pump has been running for at least 2 minutes.
On panels with a single
Temp
or
Set
button, to display the set temperature, press the button once.
To change the set temperature, press the button a second time or repeatedly to get to the desired
setting before the display stops flashing. Each press of the button will continue to either raise or
lower the set temperature. If the opposite direction is desired, allow the display to revert to the
current water temperature. Press the button to display the set temperature, and again to make the
temperature change in the desired direction.
After three seconds, the display will stop flashing and begin to display the current spa temperature.
Consider that the comfortable temperature range during use may be lower than the maximum safe
temperature. Check the set water temperature and consider lowering it for the times when the spa
will typically not be in use.
JETS / PUMP 1
Press
Jets 1
to turn Pump 1 on or off, and to shift between low and high speeds (if equipped).
High-speed will turn off after 15 minutes. Low-speed may run automatically at times for
temperature polling, heating and filtering (during which it cannot be turned off using the control
panel) but high-speed may be operated during this time.
AUX / PUMP 2 (IF EQUIPPED)
Press the corresponding button once to turn the device on or off. The device will turn off after 15
minutes.
LIGHT
Press the
Light
button to turn the light on and off. If left on, the light automatically turns off after
4 hours.
LED LIGHT (IF EQUIPPED)
Press the
Light
button to turn the LED lighting on and off. Most LED lighting will offer multiple
color modes. If you wish to change the color mode of the LED lighting, turn the lights on and off
repeatedly within a couple of seconds to rotate through available color schemes.
SPA CONTROLS - VL400 PANEL