15
Fig. 13
Fig. 14
DRIVING SCREWS
– cont’d
5.
While holding the screwdriver firmly against
the screw with both hands and the bit
aligned with the screw, squeeze the trigger
switch and drive the screw.
6.
When the screw is driven to the correct
depth, release the switch and the impact
driver will stop.
NOTE:
As the screw is driven into the
wood, the torque required to completely
drive the screw into the wood will increase.
The impact function will allow you to
continue driving the screw until it is fully
nested in the countersunk area.
7.
Release the trigger as soon as the screw is
driven to the desired depth. Failure to
release the trigger at this point will result in
an overdriven screw and possibly twist the
head off the screw.
NOTE:
To remove screws, follow the same
general procedure as for driving screws.
8.
Push the forward/reverse button to the
RIGHT for removing screws.
9.
Insert the bit fully into the screw head.
10. Hold the impact driver and bit firmly against
the screw head and squeeze the trigger
switch.
NOTE:
The impact action will allow you to
remove tight screws.
INSTALLING NUT DRIVERS FOR
3/16" to 3/8" NUTS
1.
Select the correct nut driver size.
2.
Insert the hex end (1) into the hex drive (2)
(Fig. 13).
NOTE:
See Fig. 6 for complete procedure.
INSTALLING IMPACT SOCKETS FOR
7/16" to 3/4" NUTS
1.
Insert the hex end of the socket adapter (1)
into the hex drive (2) (Fig. 14).
2.
Select the correct socket size.
3.
Push the square end of the socket (3) onto
the matching square end of the adaptor (4).
NOTES:
a) See Fig. 6 for complete procedure.
b) Make sure the socket is fully installed
onto the square portion of the adapter.
ASSEMBLY AND OPERATING
This impact driver may be used with nut
drivers and impact sockets. Although these
accessories are NOT included with this tool,
they may be purchased separately.
WARNING:
Nut drivers, socket
adaptor and sockets MUST be impact rated
and include the ANSI locking groove.
!
Fig. 12
Содержание 176578
Страница 18: ...18 EXPLODED VIEW...
