master mechanic 176578, Руководство пользователя

Страница: 13 / 20

13
Fig. 8
FORWARD/REVERSE SWITCH
This impact driver is equipped with a
forward/reverse button (1) (Fig. 7).
1.
To operate the impact driver in the forward
direction, press the forward/reverse button
to the LEFT for driving screws or tightening
nuts.
2.
To operate the impact driver in the reverse
direction, press the forward/reverse button
to the RIGHT for removing screws or
removing nuts.
NOTE: Never press the forward/reverse button
while the tool it turned ON. Damage to the tool
will result.
VARIABLE-SPEED TRIGGER SWITCH
This impact driver is equipped with a variable-
speed ON/OFF trigger switch.
1.
To start impact driver, gently squeeze the
trigger switch (2) (Fig. 8).
NOTE: The impact driver will turn at its slowest
speed when the trigger switch is depressed
slightly. The impact driver will turn at its fastest
speed when the trigger switch is fully
depressed.
2.
To stop the impact driver, release the
trigger switch.
NOTE: Operating the tool at a slow speed for an
extended period of time may cause the switch to
overheat. If either the switch gets hot, stop using
the impact driver and allow the tool to cool for at
least 15 minutes.
TIGHTENING AND REMOVING FASTENERS
The most common uses for the impact driver
are to drive or remove screws and to tighten or
loosen small nuts.
The principles for operating the impact driver
are the same for most applications. For
illustrative purposes, driving a wood screw is
shown.
LED WORK LIGHT
The LED work light (3) will automatically turn ON
when the trigger switch (2) is squeezed (Fig. 9).
It will automatically turn OFF when the trigger
switch is released.
ASSEMBLY AND OPERATING
For safety reasons, the operator must
read the sections of this Owner’s Manual
entitled “GENERAL SAFETY WARNINGS”,
“POWER TOOL SAFETY”, “SPECIFIC
SAFETY RULE
S”, “BATTERY &
CHARGER
SAFETY” and “SYMBOLS”
before using this impact driver.
Verify the following every time the impact
driver is used:
1.
Safety glasses, safety goggles, or
face shield are being worn.
2. Hearing protection is being worn.
3. Socket, nut driver or screwdriver bit
is the correct size and is
“impact
driver
” rated.
4. Socket, nut driver or screwdriver bit
is in good condition.
Failure to observe these safety rules will
significantly increase the risk of injury.
WARNING !
Fig. 7