Page 8
OPERATION
POWER INDICATOR (fIG. 1)
This Lithium-Ion battery pack is equipped
with a power indicator that displays the
battery pack’s charge status. Press the power
indicator button to display the LED lights.
The LED lights will stay lit for approximately
5 seconds.
The LED indicator will shine green to indicate
50%-100% charge. The LED indicator will shine
orange to indicate 10%-50% charge. The LED
indicator will shine red when the battery pack’s
charge is less than 10% capacity.
LED WORkLIGHTS (fIG.1)
This battery pack is equipped with two LED
worklights to provide additional light on the
surface of the workpiece for operation in
lower light situations.
To turn on the LED worklights , quickly press
the power indicator button two times . Quickly
press the power indicator button two times
again, and the LED worklights will turn off.
bATTERy PROTECTION
Integrated protective circuitry prevents the
battery pack from extreme temperatures,
over discharge, and over-charge. To protect
the battery from damage and prolong its life,
the battery pack circuitry will turn off the
battery pack if it becomes overloaded or if
the temperature becomes too high during
use. This may happen in extremely high
torque, binding, and stalling situations. The
battery pack will begin normal operation
when it cools down.
COLD WEATHER OPERATION
When the battery pack is very cold, it may
“pulse” for the first minute of use to warm
itself. Put the battery pack on a tool and use
the tool in a light application. After about a
minute, the battery pack will have warmed
itself and will operate normally.
WHEN TO CHARGE THE
bATTERy PACk
NOTICE:
This Lithium-Ion battery pack
is shipped partially charged. before using it
the first time, fully charge the battery pack.
It is not necessary to run down the battery
pack charge before recharging. The Lithium-
Ion battery can be charged at any time and
will not develop a “memory” when charged
after only a partial discharge.
Remove the battery pack from the tool when
convenient for you and your job. “Top off” the
battery pack charge by charging it for a time
before starting a big job or long period of use.
1. Use the power indicator to determine
when you need to recharge the
battery pack.
2. You can “top-off” your battery pack’s
charge before starting a big job or long
period of use.
FIG. 1
power indicator
button
LED
worklights
