Master Digit PCUWS10, Руководство пользователя

Страница: 5 / 15

5
MANUAL PCUWS10
. 1 2 3 4 5 6
Links and programming
To optimize battery charging , the threshold voltage and the charging current are
adjustable . The following shows how to set the parameters .
1. Attach the cables to the appropriate section the user PCUWS10 observing polarity.
2 . Connect the cables to the appropriate section PCUWS10 batteries observing polarity.
BATT ( 3 ) and the display ( 5 ) of the PCUWS10 indicating that the battery is properly
connected .
3 . PCUWS10 Connect to the power supply , turn the main switch (1) ON.
The POWER lamp (2) indicates that the power cord is connected to the electric user.
4 . Connect the LAN cable from the router to the internet provider PCUWS10 .
The LAN LED (4) indicates that there is a connection to the LAN.
5 . Press the UP or DOWN buttons (6) to set the display to the maximum voltage threshold
to recharge the batteries supplied by the manufacturer ( normally 27.80 V).
6 . Press the ENTER button (6 ) to continue programming.
7 . Press the UP or DOWN buttons (6) to set the display to the minimum voltage threshold to
start charging the batteries supplied by the manufacturer ( normally 23.20 V).
8 . Press the ENTER button (6 ) to continue programming.
9 . Press the UP or DOWN buttons ( 6) to set the display the charging current of the
batteries supplied by the manufacturer (usually one tenth of the Ampere battery ) .
If the value exceeds 10 amperes for which the PCUWS10 was designed or is below 50mA
one can not advance in the programming.
10 . Press the ENTER button (6 ) to start the PCUWS10 that the display will indicate the
detected voltage from the battery , the power that you are taking , the percentage yield of the
batteries (since reliable after a full cycle of discharge and recharge the batteries) and the
temperature .
If the battery voltage is less than the set voltage as a minimum threshold or for lack of
electricity network the batteries fall below the minimum threshold voltage set, the PCUWS10
begin a charging cycle in PulseMode with amperage set until the maximum voltage threshold
set .
In this mode, the display will show the voltage and current supplied to the battery as well as
a counter Watt / h supplied to the battery and Watt / h previously taken during use batteries.
If the battery voltage during the presence of the mains voltage drops below the set as the
minimum threshold , the PCUWS10 will begin a cycle of charging PulseMode desolfatante
with 1/10 the amperage set until the maximum voltage threshold set.
In this mode, the display shows the data of voltage, current, percentage yield batteries and
battery temperature.
If lack of mains or battery failure , the voltage falls below these 20Volt , PCUWS10 the user
disconnects the batteries as long as these do not exceed the threshold of 20Volt.