LIGHTING INSTRUCTIONS
WARNING: IMPORTANT!
BEFORE LIGHTING…
Inspect the gas supply hose prior to turning the gas
“ON”. If it is evident there is excessive abrasion or
wear, or the hose is cut, it must be replaced prior to
the grill being put into operation. The replacement
pressure regulator and hose assembly shall be that
specified by the manufacturer. Do not use the grill if
the odor of gas is present. Only the pressure regulator
and hose assembly supplied with the unit should be
used. Never substitute regulators for those supplied
with the grill. If a replacement is necessary, contact
the factory for proper replacement.
Screw the regulator (type QCC1) onto the cylinder.
Leak check the hose and regulator connections with a
soap and water solution before operating the grill, see
leak testing section.
TO LIGHT THE GRILL BURNER
Always keep your face and body as far from the grill
as possible when lighting.
FLAME CHARACTERISTICS
Che
burner is adjusted prior to shipment; however, variations
in the local gas supply may take minor adjustments.
ck for proper burner flame characteristics. Each
Burner flames should be blue and stable with no
yellow
tipping is normal for LP gas.If the flame is yellow, it
indicates insufficient air. If the flame is noisy and
tends to lift away from the burner, it indicates too
much air.
tips, excessive noise, or lifting. Slight yellow
Visually check the burner flames prior to each use,
the flames should look like this picture, if flames do
not, refer to the CARE & MAINTENANCE of this
manual.
customer service line.
If any of these conditions exist, call our
TO MATCH LIGHT THE GRILL
If the burner will not light after several attempts then
the burner can be match lit.
1. Open lid before lighting.
2. Turn the burner control knobs to "OFF".
3. Place a paper match in the end of the match lighter.
Strike the match and place through the cooking
grate to the LEFT burner ,
1/2" (1 to 2 cm) away.
4. Turn on the LEFT burner control knob to "MAX"
position. The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to
"OFF" and wait 5 minutes for gas to dissipate and
repeat lighting procedure.
6. Once lit, light adjacent burners in sequence by
pressing in and rotating the control knob to the
"MAX" position.
7. If the burner does not light within the first few
attempts of match lighting, there is a problem with
the gas supply. Turn off the gas at the burner and
cylinder. DO NOT attempt to operate the grill until
the problem is found and corrected. See "Trouble
Shooting" section of this manual.
1. Read instructions before lighting.
2. Open lid during lighting.
3. Ensure knobs are in “OFF” position.
4. Turn on the cylinder valve .
5. Push and turn control knob counter-clockwise
to “MAX” position until click is heard and burner
is lit. Then release knob. Adjust the flame by turning
control knob between “MAX” and “MIN” positions.
6. If ignition does not occur in 5 seconds, turn the burner
control off, wait 5 minutes, and repeat the lighting
procedure.
7. To turn off, turn control knob clockwise until it locks in
“OFF” position.
2 in.
1 in.
0 in.
1 inch
