38
LIGHTING INSTRUCTIONS
TO MATCH LIGHT THE GRILL:
If the burner will not light after several attempts then
the burner can be match lit.
1. Open lid before lighting.
3. Place a paper match in the end of the match lighter.
Strike the match and place through the cooking
grate to the LEFT burner of 1/2" (1 to 2 cm) away.
4. Turn on the LEFT burner control knob to "MAX"
position. The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to
"OFF" and wait 5 minutes for gas to dissipate and
repeat lighting procedure.
6. Once lit, light adjacent burners in sequence by
pressing in and rotating the control knob to the
"MAX" position.
7. If the burner does not light within the first few
attempts of match lighting, there is a problem with the
gas supply. Turn off the gas at the burner and
cylinder. DO NOT attempt to operate the grill until the
problem is found and corrected. See "Trouble
Shooting" section of this manual
Do not attempt to light the grill if odor of gas is
present. Call customer service
1-866-814-0585.
WARNING: IMPORTANT!
BEFORE LIGHTING…
Inspect the gas supply hose prior to turning the gas
“ON”. If there is evidence of cuts, wear, or abrasion, it
must be replaced prior to use. Do not use the grill if the
odor of gas is present. Only the pressure regulator and
hose assembly supplied with the unit should be used.
Never substitute regulators for those supplied with the
grill. If a replacement is necessary, contact the factory
for proper replacement.
Screw the regulator (type QCC1) onto the cylinder. Leak
and water solution before operating the grill.
TO LIGHT THE GRILL BURNER:
Flame Characteristics
Check for proper burner flame characteristics. Each
burner is adjusted prior to shipment; however, variations
in the local gas supply may take minor adjustments.
Burner flames should be blue and stable with no yellow
tips, excessive noise, or lifting. If any of these conditions
exist, call our customer service line. If the flame is
yellow, it indicates insufficient air. If the flame is noisy
and tends to lift away from the burner, it indicates too
much air.
Visually check the burner flames prior to each use, the
flames should look like this picture, if flame do not, refer
to the CARE and MAINTENANCE of this manual. If they
Keep a spray bottle of soapy water near the gas
supply valve and check the connections before
each use.
2
1
0
1 inch
test the hose and regulator connections with a soap
This is a LP grill not a NG grill - there is no gas supply.
persist, call our customer service line.
2. Make sure turn the burner control knobs to "OFF".
in.
in.
in.
1. Read instructions before lighting.
2. Open lid during lighting.
3. Ensure knobs are in “OFF” position.
4. Turn on the cylinder valve.
5. Push and turn control knob counter-clockwise to “MAX”
position until click is heard and burner is lit. Then release
knob. Adjust the flame by turning control knob between
“MAX” and “MIN” positions.
6. When igniting the rotisserie burner, keep control knob
pressed for 30 seconds once burner is lit.
7. If ignition does not occur in 5 seconds, turn the burner
control off, wait 5 minutes, and repeat the lighting
procedure.
8. To turn off, turn control knob clockwise until it locks in
“OFF” position.
