05/15 Rev. C 146574
2
Install casters per the following diagram.
Note: Casters and bolts can be found packaged inside the cabinet. Install casters with
brakes to the front of the prep table. The cabinet bottom has pre-punched holes for
caster mounting. Install caster bolts tight to prevent future damage to cabinet base from
loose casters.
MAINTENANCE
General Cleaning
Beginning with the initial installation, the interior surfaces of the cabinet should be
periodically cleaned with a solution of warm water and baking soda. This solution will
remove any odors from spillage that has occurred. The exterior of the cabinet should
also be cleaned frequently with a commercial stainless steel cleaner, glass cleaner or
mild soap solution. Do not use chlorinated cleaners on the stainless steel surfaces.
Note: do not use stainless steel cleaners or other solvent-based chemicals on the plastic
parts (door handle or trim strips) as they can cause failure. Use mild soap and warm
water on plastic parts.
The door gaskets should be cleaned in place with a mild soap solution to extend their
life.
The shelving can be cleaned in a sink with a mild soap solution and a soft bristled brush.
Condenser Coil Cleaning
Prior to cleaning the condenser coil disconnect the unit from power. Periodic cleaning of
the condenser coil will aid the heat transfer of the refrigeration system and increase its
efficiency. To accomplish this, remove the front grill from the cabinet. The condenser
coil is located behind the grill. Use a soft bristled brush to remove any dirt particles that
are on the fins of the condenser coil. Use a vacuum cleaner or compressed air to
remove the loosened particles. Replace the grill and reconnect the unit to power.
Failure to clean the condenser coil can lead to performance loss and compressor failure.
Stocking
When loading the cabinet with contents, do not block the fan on the right side. Blocking
the air flow may decrease performance.
