29
30
5.1.1 When the “ ” symbol is displayed, the batteries
should be replaced immediately.
5.1.2 Turn the range selector to OFF and remove the test
wires from the input terminals.
5.1.3 Unfasten the screws and remove the battery cover.
5.1.4 Mount new batteries, replace the battery cover and
fasten the screws.
5.2 Replacement Of Fuse
WARNING
Before opening the battery cover, remove the
test probes from the circuit under test to avoid
the risk of electric shock.
To avoid fire hazards, be sure to use the
designated fuse (at rated voltage, amperage
and blow rate).
5.2.1 Turn the range selector to OFF and remove the test
leads from the input terminals.
5.2.2 Remove the protective cover and unfasten the
screws.
5.2.3 Remove the rear case, pry up one end of the fuse
gently and then remove the fuse from the clip.
5.2.4 After a new fuse is mounted, replace the rear case
and fasten the screws.
5.3 Replacement Of Test Probes
WARNING
The test probes must be replaced with those
of the same model or class, and must be kept
in good condition. Ratings of test probes:
CAT III 600V 10A.
If the insulation of any test probe is damaged, e.g., a wire
is exposed, the test probe must be replaced.
