MASSEY FERGUSON MF1844, Руководство по обслуживанию

Страница: 15 / 31

4283475M2 01-9
General Information
Service Chart
The following service chart lists all components and
grease fittings that can be serviced, in order of frequency
in hours, according to normal operating conditions. Each
of the service points in this list are shown in the photos in
this division. See Lubrication section in the Specifications
Division for the correct type and quantity of lubricant.
Frequency Maintenance Point Maintenance
Frequently Roller chain Lubricate
Daily or every 10
hours Hydraulic oil Check oil level and add if necessary
Air inlet screen Inspect and clean
ARI (Air Restriction Indicator) if equipped Clean or replace air filter when
indicator shows a red bar.
Tires Check condition and pressure
10 hours Stuffer crank Lubricate
20 hours Pickup overrunning clutch Lubricate
Needle carriage tie rods Lubricate
Gearbox Check oil level
Knotter Lubrication System Check oil level and add if necessary
After the first 50
hours Hydraulic oil filter Change
Bale density hydraulic filter Change
50 hours Baler drive belt tension bracket Lubricate
U-joint and slip tube in rear of drive shaft Lubricate
Tongue pivot Lubricate
Flywheel Lubricate
Pickup drive shaft U-joints Lubricate
Knotter clutch arm pivot Lubricate
Plunger connecting rods Lubricate
Knotter trip arm pivot Lubricate
200 hours Gearbox Lubricate
250 hours Pump drive belt Check tension
Hydraulic oil filter Change
500 hours Hydraulic breather filter Change
Bale density hydraulic filter Change
Each season Wheel bearings Clean and lubricate
Gearbox breather Clean or replace
Knotter lubrication system Replace filter
Hydraulic breather filter Change