Masport F39 Room Sealed Freestanding Gas Fire
17
ADJUSTING FLAME
HEIGHT
Your heater has an adjustable flame to tailor
the look and heat output to your specific
needs. It is adjusted by turning the flame
adjustment dial on the gas control valve.
Turn clockwise to adjust the flame higher,
counterclockwise for a lower flame.
OPERATING INSTRUCTIONS
OPERATING
INSTRUCTIONS
Before operating this appliance, proceed
through the following check list.
1) Read and understand these Instructions
before operating this appliance.
2) Check to see that all wiring is correct and
enclosed to prevent possible shock.
3) Check to ensure there are no gas leaks.
4) Make sure the three pieces of door glass
are properly positioned. Never operate the
appliance with any of the glass removed or
with the door open.
5) Verify that all fluing and the cap is unob-
structed.
6) Verify log placement. If the pilot cannot be
seen when lighting the unit - the logs or the
embers have been incorrectly positioned.
7) The unit should never to turned off and on
without a minimum of a 60 second wait.
LIGHTING
INSTRUCTIONS
1) Push in gas control knob slightly and turn to
“PILOT” position.
2) Push in control knob all the way and hold in
until the pilot lights up. Continue to hold the
control knob in for about 20 seconds after the
pilot is lit. Release knob.
3) Push in gas control knob slightly and
turn to "ON" position.
4) Turn ON the flame switch.
During the first few fires, a white film
may develop on the glass front as part
of the curing process. The glass
should be cleaned or the film will bake
on and become very difficult to re-
move. Use a non-abrasive cleaner and
NEVER clean the glass while it is hot.
SHUTDOWN
INSTRUCTIONS
1) Turn OFF the flame switch.
2) Push in gas control knob slightly and turn to "OFF"
position.
FIRST FIRE
The FIRST FIRE is part of the paint curing
process. To ensure that the paint is properly
cured, it is recommended that you burn your
fireplace for at least four (4) hours the first time
you use it with the fan on. When first operated,
the unit will release an odour caused by the
curing of the paint and the burning off of any oils
remaining from manufacturing. Smoke detec-
tors in the house may go off at this time. Open
a few windows to ventilate the room for a
couple of hours. The glass may require clean-
ing.
DO NOT ATTEMPT TO CLEAN THE
GLASS WHILE IT IS STILL HOT!
Note: When the glass is cold and the
appliance is lit, it may cause con-
densation and fog the glass. This
condensation is normal and will
disappear in a few minutes as the
glass heats up.
DO NOT BURN THE APPLIANCE
WITHOUT THE GLASS FRONT IN
PLACE.
AUTOMATIC
CONVECTION FAN
OPERATION
Set the fan speed on control panel at the top
rear of the unit to adjust to the desired speed.
The fan will turn on as the stove comes up to
operating temperature. After the unit has been
turned off and the unit cooled to below a useful
heat output range the fan will shut off automat-
ically.
