Masport P36-3 Gas Inbuilt
21
STANDARD FLUSH DOOR
Diagram 3
Use the hook to pull the spring out until you can
put the hook into the slot on the bottom door
bracket. Repeat for 2nd spring. See diagram 3.
Diagram 2
The standard flush door comes with a black
frame. To install the frame, simply hook the top
door flange onto the top of the unit and swing
the door towards the unit, diagram 1.
Be careful that the glass gasket does not roll up;
there must be a gap between the gasket and the
door lip to ensure that the door sits securely on
the unit. Diagram 2.
Diagram 1
To remove the flush door, reverse the above
steps.
Optional Flush Trim
Attach the round
magnets to the
back of the top trim
piece and to the
bottom trim piece,
then attach trim to
the top and bottom
of Flush door.
Flush Louvres
1) Install the top louvre by sliding the two
bracket clips into the brackets located un-
derneath the top of the firebox.
2) The bottom louvre has a hinge that is at-
tached (2 screws per hinge) to the lip on
bottom of the unit.
Note: Top and bottom louvres are
different.
INSTALLATION
10) Place the embers on the front of the burner
tray in the places shown on the photo.
11) Test fire to ensure proper light off (make sure flame flows smoothly from one end of burner
to the other). If there is any flame hesitation, check that area for any blockage of the burner
ports.
12) Install flush glass and bay glass (if used) as per instructions in this manual.
Place embers in these 3
locations on the burner tray.
Embers
02-50
02-55
02-49
02-53
02-51
02-54
02-52
