22
23
NOTE:
1. The rear burner valves operate with the electronic ignition.
2. All the side burner valves operate with the integrated ignition.
Check the diagram of module to determine the BBQ ignition type
3. If the module has only one pin i.e. connecting single wire then Rear burner operates with electronic ignition
4. If the module has multiple pins for connecting the wires then Rear burner and Main burners operate with electronic
ignition.
Single Pin Electronic
module
4 Pin Electronic module
6 Pin Electronic module
7 Pin Electronic module
Ignition module attached on
the Right side Table
Follow the diagram to connect the wires between the electronic module and the electrode.
Connect the lead wire with the electronic ignition as shown below. Make sure that the wire is clipped tight.
SINGLE PIN ELECTRONIC MODULE:
Connect the lead wire with
the electronic ignition, no
sequence is required,
Connect the lead wire with
the electronic ignition, no
sequence is required,
4 / 6 / 7 Pin Electronic Module:
1.
Total 7 pcs of the
lead wire for all
main burners and
rear burner.
2.
The assembled
position of the
electronic ignition
The assembled
position of the
electronic ignition
3.
Connect the lead wire with the ignition as shown below, no sequence is required, make sure that the wire is securely clipped.
Connect the lead wire with
the electronic ignition, no
sequence is required,
NOTE:
Make sure that the wires are securely positioned on each end and routed through the wire clips.
The BBQ body works as an earth for the electronic module. Make sure that the side table is assembled tightly and forms the complete
circuit. If not, the ignition spark will not occur.
CAUTION
: All wires must be properly routed through wire clips.
Verify the ignition system of your BBQ model before connecting the regulator to the gas cylinder
1. Integrated ignition valve - Push in then turn the knob anticlockwise to HI. Test each burner to hear a clicking sound with spark. It indicates the valve
is fitted with integrated ignition.
2. Electronic ignition - Install the battery in the electronic module fitted on the RH side table. Make sure the battery is in good condition and the battery
polarity is correct. Push the button to hear a continuous clicking sound with spark.
Listen & look for the sparks at all the burners’ individually and make sure that all the valves are functioning smooth by turning them
“ON” (by
pushing the control knob in and turning anticlockwise) and “OFF” (by pushing the control knob in and turning clockwise).
