20
21
14. Loosen the 3 Screws (item b), remove the 4th & 5th screws, then assemble the heat shield (item 33) and left hand side shelf (item 16) to the
appliance with 5pcs Screw (SS) M6*12 (item b). Level the top of the table and secure.
If the timer knob is not fitted then, fit one knob (item 15) on the shaft of the timer on the side table. Refer to the timer section for correct operating
procedure.
15
Screw SS M6*12 (b)
16 (b)
33
4th & 5th
15. 1) Remove all packaging from the side burner prior to fitting the Right Hand (side Burner) table to the BBQ. Prepare the BBQ prior
to fitting the side table, refer to previous instructions. Then assemble the Side burner assembly (item 17) as described in step
13. If the knob (item 15) has not been fitted then assemble the knob (item 15) to the valve shaft on side burner assembly (item
17), and make sure the red point on the knob is on the upper direction.
2) Connect the side burner hose to the main manifold, and tighten carefully.
Note!
Before operating this appliance for the first
time LEAK TEST ALL JOINTS.
16. Put the Drip tray (item 18), Grease cup (item 19) into the grill body and 2pcs Step screw (item e) - (the step screws will be on the
assembly already) to the rear of the grill body to secure the drip tray.
NOTE:
Some barbecue models require the stepped screws (item e) are removed to insert the drip tray. Once the tray is positioned
correctly, refit step screw (item e).
17. Insert the wiring plug of transformer into the bottom of the transformer connector. And then fasten the nut by turning clockwise.
18. Insert the wiring plug of USB into the USB port (if included in your model of BBQ).
19. Connecting the ignition wire/ wires to the electronic module
