18
546565.A.3 - May 2019
OPTIONAL ROTISSERIE - ASSEMBLY
INSTRUCTIONS
TOOLS NEEDED FOR ASSEMBLY
Crosshead screwdriver, 10mm A/F spanner, 2x 8mm A/F Spanners.
Assemble the Prong (24), the Rod (25) and the Guide (27), the
Rotisserie handle (28) together as in the diagram.
NOTE:
Rotisserie Rod 25 is threaded LH, assemble by turning
rod anti-clockwise. Tighten with 8mm A/F Spanners.
This connection must remain spanner tight.
Place inside of grill
Assemble the Motor holder (29) to the appliance with 2pcs Screw
M6*10 (a), 2 fibre washer (c) and 2pcs Nut M6 (f) as the
diagram. Place the battery (31) into the Motor (30). Assemble the
Motor and Rotisserie to the appliance as the picture.
NOTE:
Take note of the b - positions prior to fitting the
batteries.
NOTE:
There is an option to use a mains adaptor (not stocked).
Requires:
Mains adaptor 240 volt > 3 volt DC 3 milliamps or
greater.
LEAK TESTING
WHEN TO TEST:
The BBQ gas bottle, regulator & hose assembly should be checked
for leaks, using the soapy water leak test, every time you reconnect
your regulator to the BBQ gas bottle. You should also test after any
long period of non-use, such as at the beginning of BBQ season.
WHAT TO USE:
You will need a soapy water solution to check for any leaks. Mixing
liquid hand soap with water will work fine (do not use any other
household cleaning products).
HOW TO TEST:
Put some soapy water in a spray bottle or a dish. Turn on the gas
bottle but do not turn on the BBQ. Next, spray the entire valve,
regulator and hose assembly with the soapy water including where
the hose connects to the BBQ. Alternatively, you can apply the
soapy water with a paint brush, basting brush.
Bubbles will form if there is a gas leak and you may also smell the
gas. If you find a leak, turn off the gas bottle immediately!
Do not turn back on or attempt to use the BBQ if a gas leak has
been detected, contact your local BBQ Dealer for repair.
INSTALLATION
This barbecue is for outdoor use only and should be placed in
a well-ventilated area. Take care to ensure that the minimum
clearances guidelines are followed:
Minimum clearances:
From sides: 430mm; From back: 430mm
From above (vertical): 1000mm
Keep this barbecue away from any flammable materials! This
appliance shall only be used in an above ground open-air situation
with natural ventilation, without stagnant areas, where gas leakage
and products of combustion are rapidly dispersed by wind and
natural convection. This barbecue is not designed for marine use.
Any enclosure in which the appliance is used shall comply with one
of the following:
1. An enclosure with walls on all sides, but at least one permanent
opening at ground level and no overhead cover.
2. Within a partial enclosure that includes an overhead cover and
no more than two walls.
3. Within a partial enclosure that includes an overhead cover and
more than two walls, the following shall apply:
a. at least 25% of the total wall area is completely open and
unrestricted.
b. at least 30% of the remaining wall area is open and
unrestricted
Содержание Barbecues
Страница 27: ...27 546565 A 3 May 2019 ...
