Installing the Gas Burner
Attaching the Burner and the Grate
1.
Unpack the burner assembly and place the side legs of
the burner into the brackets on the side of the firebox
(see Fig. 15-1).
2.
Connect the supplied flex connector to the input of the
burner valve, from the gas stub down stream from the
required manual shut-off valve.
Note:
The required 1/8" NPT up stream pressure tap
is built into the valve (Fig. 20-1).
CAUTION:
C H E C K A L L C O N N E C T I O N S F O R
GAS LEAKS USING A HALF-AND-HALF
SOAPY WATER SOLUTION. IF A LEAK
IS DETECTED TIGHTEN CONNECTIONS
AND TEST AGAIN.
NEVER USE AN OPEN
FLAME TO CHECK FOR GAS LEAKS.
3.
Insert a one-way screw into the hole in the front of each
grate bracket and tighten with a long (min. 12") screw
driver until contact is made with the grate leg and the
grate is permanently locked in place (see Fig. 15-1).
4.
Place the heatshield over the valve.
Important:
Once installed the burner can not be
removed.
5.
Fill in the holes you have drilled around the gas piping
with the regular MASON-LITE mortar.
Checking and Adjusting the Pilot (if neccessary)
1.
Follow the lighting instructions to light the pilot. The pilot
flame should encircle the generator tip which is preset at
the factory (Fig. 20-2). Ordinarily, the pilot will not require
field adjustment.
2.
If adjustment is necessary, remove the cap screw
(Fig. 20-1) and turn the smaller gas adjustment screw
inside counterclockwise to increase the pilot flame and
clockwise to decrease the pilot flame. Replace cap screw.
Fig. 20-2
Note:
Pilot flame should
Heat shield placement
Cover the valve with the heat shield.
The heat shield must
remain in place over the valve at all times during operation.
Keep the area above the heat shield clear of logs or any
other object.
CAUTION: DO NOT place the wire bundles on, under,
or near the heat shield, burner, or valve.
Adjusting Air Mixers
Burners are equipped with air mixers for the top and front
burners. Adjust the size and color of the flame by opening
(turn outward) or closing (turn inward) as shown in Fig.
20-3, 4.
Placing the Decorative Lava Rock
If desired, open the bag of lava rock and pour its contents
around the base of the grating in an attractive pattern. Do
not place the Lava Rock on the logs or grate.
Open
Fig. 20-3
Fig. 20-4
Fig. 20-1
encircle tips of
the electrodes.
REV 1 - 0907231405
20
L-A2-27509
