Mash Dirt Track 50CC, Руководство пользователя

Страница: 29 / 66

29
Note :
After engine ignition, immediately release the starting button, to avoid
adverse effects to the engine.
.
If the engine is not started after 5 seconds, wait for 10 seconds before
making another attempt to prevent damaging the battery.
In case of failure in engine starting after two or three attempts, rotate the
accelerator grip for 1/8 or 1/4 turns and try again.
A motorcycle not used for a long time and poor atomizing fuel may result in
starting difficulty. In this case, do not rotate the accelerator grip, but repeat
starting.
Cold engine
Put the carburetor enrichment handle (plunger carburetor) or lever
(vacuum carburetor) to the highest position (plunger) or pull it fully out (vacuum
carburetor), keep the accelerator closed, and press the electric start button;
After the engine is started, press the handle half way down (plunger) or push
the lever half way in (vacuum) and wait for the engine is adequately warmed-
up, before putting the handle or lever to the original position. The colder it is,
the longer warm-up time the engine takes. Otherwise, the acceleration may be
poor.
Warm engine
Rotate accelerator grip for 1/8 - 1/4 turns, and press electric start button to
start the engine. When the engine is warm, it is not necessary to use carburetor
enrichment system.
Warning
Never start the engine in a room with poor or no ventilation. It is
because carbon monoxide gas is poisonous. Never leave the motorcycle
unattended with a running engine.
Precaution
Do not allow the engine run for a long time without driving, or the
engine may get overheat causing damage to internal parts or chrome
plating of exhaust system.