Maserati GRANCABRIO RANGE, Руководство пользователя

Страница: 87 / 262

3
85
Programming devices controlled by
alternate code
- Locate the specifi c setting button
by consulting the user manual of
the system to be controlled. This
button is normally located on the
motor which drives the device.
- Press the button and, in normal
conditions, a LED will illuminate.
WARNING: normally, after this
operation you have 30 seconds to
start the next one.
- Briefl y press the HomeLink button
you have chosen to control the
device.
- Press it a second time; when it
is released the operation should
be completed. For some types of
motors, the button might have to
be pressed a third time.
Reprogramming an individual
button
If you wish to program activation
of a new system on an already used
HomeLink button, proceed as follows:
- press and hold the HomeLink
button selected;
- after about 20 seconds, the LED
R starts fl ashing; hold the button
down;
- hold the original remote control of
the device to be controlled close to
the HomeLink control panel (0-30
cm/0-12 in);
- press and hold the button on the
original remote control;
- successful programming is signalled
by the LED R fl ashing faster;
- release both buttons.
The system previously programmed
on HomeLink has thus been replaced
with the new programming and is
ready to be used.
This operation has no impact on the
other HomeLink buttons.
Deleting the programmed buttons
Unlike programming, which is
performed for each individual
button, all three buttons are deleted
simultaneously.
To delete proceed as follows:
- press and hold buttons
O and Q ;
- after about 20 seconds, the LED R
starts fl ashing;
- release the buttons.
WARNING: It is advisable to perform
the HomeLink deletion procedure
when selling the vehicle.