PNEUMATIC PLANTER «FUTURA – FUTURA
Maxi
»
INSTRUCTION FOR THE USE AND MAINTENANCE
- 12 -
characteristics of the machine and so cause
the working safety.
-
Therefore the Manufacturer decline every
responsibility for all the damages that should
rise for using not original parts.
- The machine must be used only for the
purposes it has been designed for, at the
paragraph 1.4
-
The machine must not work with the
protections disassembled.
CAREFUL
It is strictly forbidden the machine to be
actioned by who has not read the manual.
-
Pay attention to signals of danger reported in
this manual and on the machine itself.
-
Before to put the machine in function, check
the full integrity of all the safety devices for
the transport and use of the machine itself.
- Before to start working, look at the control
devices and at their functions.
-
When a person is “
exposed
” it means, that is
in a “
danger zone
”, the operator must
immediately operate to stop the machine and
to send away the person in question.
Picture 5 – DANGER ZONE
During the machine functioning mode, it is
absolutely forbidden to get near it, while the
mechanic components are moving.
-
It is absolutely forbidden to transport persons
or animals on the machine.
-
It is absolutely forbidden to leave the driving
place, when the tractor is working.
-
It is absolutely forbidden to remove the safety
devices.
- Suitable clothes are to be used, avoiding
absolutely flapping dresses or borders. They
could get caught into the rotating parts or into
the components, while moving.
-
It is absolutely forbidden to interpose yourself
between the tractor and the equipment
(picture 5), when the engine is on on, and
without actioning the stationary brake and
putting a block of suitable dimensions under
the wheels.
- Before leaving the tractor, the device
connected to the lifting group is to be lowered
down, the motor to be stopped, the stationary
brake to be connected, and the switching key
of the control board to be removed. Make
sure nobody can approach to the chemical
substances.
-
The movements out of the working zone must
be executed with the device in transport
position.
-
Before putting the machine on working mode,
it is to be controlled, the standing feet (1
picture 11) have been taken off from the lower
part of the machine and that the planter has
been correctly installed and adjusted; it is to
be checked, that all the components
subjected to wear and to deterioration are
efficient.
Picture 6 – STANDING FEET
All the maintenance adjustments or working
operations must be made absolutely with the
machine on the soil and on standing feets, the
tractor has been switched off and the key
disengaged.
-
Pay attention to the PTO shaft in rotation
phase.
Read carefully also the included instruction
manual of the PTO shaft.
-
In order to mount and to dismount the PTO
shaft, it is necessary to leave the protection
cap placed on the planter, it is obligatory ,
after the assembly or the disassembly, always
to re-put the cap.
