Cleaning Device PWA 1000i Page 21
8. Operating Instructions
To use this cleaning device, you have to read the operating manual first! A
commissioning without attention of the operation manual can cause damage
to persons, objects and the environment. Please wear personal protective
equipment
3.3 Safety Precautions
•
Fire and ignition sources are not allowed in an area of 5m around the device (such as
grinding machines or welding plates). Smoking is also forbidden!
•
Please mark areas which are vulnerable to flames with appropriate signs.
•
Compressed air supply has to be guaranteed.
The following solvent drums are required:
1 x 60 liters drum filled with 30 liters and 1 x 30 liters drum filled with 30 liters.
8.1 Commissioning
1.
Remove the front cover of the machine and position the drums as shown on page 5.
2.
Insert the black discharge hose (
∅
23) and grey intake hose into the 60 l drum, which is
provided for contaminant dilution and circulating material. Insert the transparent intake
hoses into the 30 l drum provided for fresh thinner and material.
3.
Replace the front cover of the machine.
Now, the cleaning device is ready to work.
8.2 Operational Procedure
Working with the manual side of the machine (cf. pages 4f)
Open the door. The exhaust starts automatically. Activate the pump of the brush with the toggle
switch labeled
„Brush“
. Circulating solvent flows out of the brush. The output can be adjusted with a
pressure reducing regulator that is located in front of the pump. Activate the pump of the spray jet
with the
toggle switch labeled „fresh Jet“.
Fresh solvent flows out of the spray jet (30 liters drum).
You can adjust the output at the throttles as needed with the black throttle valve behind the
operating panel.
When the manual cleaning area is not longer in use, switch it off and close the door. The exhaust
stops automatically.
With the jet gun, positioned at the front of the machine, you can dry objects or spray guns. If you
unclamp the compressed-air quick connect, you can substitute the jet gun by the cleaned spray gun
and exhaust it in the exhaust opening.
