12
4.2
Setup software (Dashboard)
4.2.1
After charging boards download the
latest stable software package
from
http://www.marvelmind.com/#Download
4.2.2
Select the SW version of the portable or distribution and unzip
4.2.3
Then run the
Dashboard
and update the SW using
Dashboard
=>
Firmware
=>
Choose the file
=>
Program
4.2.4
Ensure that you are (a) programming beacon’s SW to beacon; (b) you are using SW for 4.9, if
you have HW v4.9; (c) you have the SW from the same, i.e. Dashboard SW and beacon SW
must be from the same SW pack. Don’t mix SW releases
4.2.5
While beacon is connected to the Dashboard, press Default button to upload the default settings
4.2.6
Write down and use later the beacon’s address or change the address to your convenience as
shown
here
4.2.7
Press RESET button on your beacons after programming
4.2.8
After programming devices with the latest software beacons are ready for use.
Place stationary beacons on the walls vertically in such a way that optimal ultrasonic coverage is
provided. To start with the system it is recommended to use a simple room of 4x6 meters or so
and place the stationary beacons on the opposite walls on 1.85m height (default). After
familiarizing with the system far more complex configurations can be done. Here is the help
video
