6
6. Plug the cord into an electrical outlet. Ideally, the Coffee Brewer should be operated on its own circuit, separate from other appliances.
7. When plugged in, a white light around all buttons will flash three times and then all lights will turn off.
NOTE:
If the decorative front cover is not closed when the power cord is plugged in, then all buttons will flash in red until the front
cover is closed. When closed, the lights will all turn off.
8. Press and hold the POWER button for 3 seconds. The POWER button will flash and the cleaning cycle will begin.
9. The Brewer will pump water for approximately 25 seconds and then pause for approximately 10 seconds. This cycle will repeat 5
times and the POWER button will flash for the entire cleaning process. At the end of the 5th cycle, the pump will push air for a few
seconds. When the cleaning cycle is complete, the POWER button will turn off.
10. The Coffee Brewer is now ready for use.
BREWING COFFEE USING A K-Cup
®
CAPSULE
1. Place the Coffee Brewer on a dry, level and heat-resistant surface.
2. Fill the Water Tank to the MAX line and place the Water Tank on the Brewer and put the Lid on the Water Tank.
3. Plug the cord into an electrical outlet. Ideally, the Coffee Brewer should be operated on its own circuit, separate from other appliances.
4. When plugged in, a white light around all buttons will flash three times and then all lights will turn off.
NOTE:
If the decorative front cover is not closed when the power cord is plugged in, then all buttons will flash in red until the front
cover is closed. When closed, the lights will all turn off.
5. Raise the decorative front cover. When raised, all buttons will flash in red until the front cover is closed. When closed, the lights will
all turn off.
6. Slide out the Capsule Holder.
7. Insert a K-Cup
®
capsule into the Capsule Holder.
NOTE: Never remove or puncture the foil top of the K-Cup
®
capsule before inserting it into the Coffee Brewer.
8. Place the Capsule Holder into the Brewer and close the decorative front cover. The K-Cup
®
capsule will be punctured on the top and
bottom allowing for the ideal flow of water during the brewing cycle.
NOTE: If the decorative front cover is not properly closed, the capsule may not be punctured and the brew cycle may fail.
9. Place a mug on the Drip Tray and under the Brew Spout.
TIP: Be sure to keep the mug in place at the end of the brew cycle to catch any excess drips. The end of the brew cycle
is indicated when all lights turn off.
10. Press the Power Button. The light around the Power Button will be solid white and the lights around the Cup Size Buttons will flash
white.
11. Press the desired Cup Size Button (6 oz, 8 oz or 10 oz). The Cup Size Button pressed will become solid white and the brew cycle
will begin.