Starting and Stopping
Before Starting the Engine
1.
Fill the fuel tank as instructed in the Before Operation section of this
manual.
2 Rest the Hedge Trimmer on the ground
..
3. Make sure the cutting blades are clear of branches, shrubs, debris
etc.
4.
Keep all bystanders, children and animals away from the working
area.
Cold Starting Procedure
This engine is equipped with a fuel primer and a choke system To start
a "cold" engine properly, perform the following procedure:
1. Pump the primer bulb at the bottom of the carburetor until fuel can
be seen flowing through the fuel return line to the fuel tank. (Flowing
fuel should be almost clear, not foamy or full of bubbles .. )
2 Move the choke lever to the closed ( I ) position
3.
Set the stop switch to the "ON" position. The throttle trigger posi
tioned at idle
4. Grasp the starter grip and slowly pull the starter cord out until you
feel some resistance, then pull the cord quickly and powerfully .. Pull
the starter grip until the engine starts. After the engine is started,
turn the choke lever to the Open ( == ) position.
NOTE:
-Do not pull the starter cord out completely.
-Do not release the starter cord from the fully extended position.
5.. After starting, allows the engine to run a few minutes to warm it
before using.
Hot Restart
For starting the engine that is already warmed up (hot restart), turn the
choke lever to the Open ( == ) position and follow steps 3 and 4 only.
If the engine fails to start after three to four pulls, follow the Cold Starting
Procedure section above.
To Stop the Engine:
1
..
Release the throttle trigger
2. Slide the stop switch to "STOP" position
..
-17-
Primer bulb �----<
Fuel return line
Choke lever
STOP �
Stop switch
� START(ON)
-
Idle position
,,
,,
-
-
-
.,
Throttle
.
..
EHT2321DSL
Stop switch
(
\
(
ld!e position
(
EHT2321D
