Loop Handle Installation [ Model: EHT2321 D ]
1. Slip the rubber sleeve around the shaft approximately 9inches
(23cm) from the end of the stop switch/throttle trigger assembly for
an initial handle position.
2. Rotate the rubber sleeve so the split is to one side ..
3. Place the loop handle and the bottom clamp over the rubber sleeve
4.. Install the four screws and nuts. Tighten the screws evenly
Before Operation
Oil and Fuel
WARNING: The following precautions will lessen the risk of fire.
1 . Do not smoke near fuel.
2.
Mix
and pour fuel outdoors and where there are no sparks or
flames.
3. Always shut off the engine before refueling. Never remove the
Hedge Trimmer fuel tank cap while the engine is running or immedi
ately after stopping the engine ..
4. Always open the fuel tank cap slowly to release any possible pres
sure inside the tank ..
5. Do not overfill the fuel tank .. Stop filling 1/4-1/2 inch (6mm-13mm)
from the top of the tank ..
6. Tighten the fuel tank cap carefully but firmly after refilling ..
7. Wipe up any spilled fuel before starting the engine.
8. Move the Hedge Trimmer at least 1 Ofeet (3m) away from the fueling
location and fuel storage container before starting the engine.
-13-
Loop Handle
Rubber
Sleeve
Bottom Clamp
10 feet (3m) Minimu1/
!JJ
(
