OPERATING THE POWER EDGER
CAUTION-Read the SAFETY INSTRUCTIONS on page(2J concerning
the proper use of the Power Edger.
The MARUYAMA Power Edger is designed for edging and tested to
c .. ut nearly all grasses and thick weeds. As you continue to use
the equipment, many tasks will become easier.
By adjusting the handle, the MARUYAMA Power Edger can be
operated while standing in a natural position, and can only be
positioned at the right si.de of the operator. To adjust the loop
handle, see the ASSEMBLY INSTRUCTIONS on page (3).
If it is necessary to reposition the shaft grip, loosen the
clamping screw of the throttle trigger assembly before moving
the grip. Then use caution to prevent any damage to the throttle
cable and stop-switch connections.
Be sure the throttle trigger assembly is in place firmly against
the shaft grip before tightening the clamping screw.
Adjust the blade guard to a position that does not
contact with the blade and shields the operator
thrown debris.
(See ASSEMBLY INSTRUCTIONS for blade guards.)
CAUTION-Remove
tools before
equipment!
any
holding
operating the
The cutting
established
the engine.
depth
before
should be
starting
To adjust the cutting depth, first
loosen the clamping-knob. Then rotate
the blade guard forward or backward
until the desired cutting depth is
acquired ( see sketch). Tighten the
clamping-knob ONLY AS NEEDED.
/),,,. Always operate the Power Edger
.-A
positioned at the RIGHT-SIDE
of the operator (see sketch).
Be sure the blade is rotating (at
least half-thrott1e) before inserting
it into the cut. The Power Edger
performs best at full throttle.
/),,,. Always use eye protection when
.-A
operating the edger.
-8-
CLAMPING-KNOB
··--:.-:J;,;:_�� -
,J,,,;-� ••
·-?tt��t' --
DIRECTION OF TRAVEL.,·;�::
make
from
