OPERATING INSTRUCTIONS
STARTING PROCEDURE
The carburetors on MARUYAMA
system and are designed to
throttle setting will cause
start a .�'cold" engine, perform
engines do not contain a choke
start at IDLE speed. A gi;eater
difficult starting. To properly
the following procedure.
Step #1) Pump _the primer-bulb at the
bottom of the, carburetor·
until fuel can be seen
flowing
through
the
fuel-return line to the
fuel tank. (Flowing fuel
should be clear, not foamy
or full of bubbles.)
5-tep #2) Fully depress the
injection
button,
release.
black
then
Step #3) With. .the ignition switch
"ON" , and the throttle
trigger positioned at IDLE,
pull the .starter cord. The
engine should start at IDLE
within 5 to 6 pulls.
PUMPJ
=
PRIMER BULB
FUEL-RETURN LiijE
PULL TO START -
·. ,
-
INJECTION BUTTON
1
� �-'
�-
.
(
STOP
""'
sw.t_TCH
� START(ON)
AST-IDLE POSITION
IDLE POSITION
THROTTLE TRI GER
For stcirting cin _engine thcit is already .. warmed-up(hot restart)-,
or if the ambient temperature exceeds 70
°
F(20
°
C), the injection
button should not be used. Follow steps #1) and #3) only;
If the engine fails to start at the IDLE position, set the
throttle trigger at the FAST-IDLE position (see sketch).
Then repeat the starting procedure (prime, injection, and pull),
(If a MARUYAMA engine fails to start after following the above
procedures, contact an authorized MARUYAMA dealer.)
-6-
