24
◼
Reagent Preparation and Handling
(1) Reagent Preparation
[1] Before preparing the reagent, check the spray
condition with water.
(Refer to P.**.)
[2] Prepare only the required amount using a dedicated
container.
[3] Dissolve the water-dispersible powder well with a
small amount of water and then add the diluted
powder.
[4] Confirm that the main spray cock and spray cock
are in the
“Closed” position and the liquid feed valve
is
“Open,” and then press the spray pump switch.
The spray pump will actuate and agitation will start
in the reagent tank at the same time.
[5] Put the reagent in the reagent tank by making sure
it does not spill out of the tank, and agitate the
reagent fully.
Caution
⚫
The spray pump and jet agitation are
interlocked. Once the spray pump stops, jet
agitation also stops. Do not stop the spray
pump while reagent remains in the tank,
because chemical damage may occur.
Caution
⚫
Carefully read the operation manual of the
applicable reagent and use the reagent
correctly.
⚫
Be sure to use the water filter net and when the
spraying is over, clean the net together with the
water absorption strainer/discharge strainer.
