18
◼
Other
(1) How to Install/Remove the Side Cover and the
Hood
[1] To remove the hood, remove the two knob bolts A
on the left and right, and hold it at the left and right
latch positions to pull it out.
[2] To remove the side cover, loosen the four knob
bolts B on the left and right, and pull it toward you.
[3] Perform the same steps in the reverse order to
install the cover or hood.
Caution
⚫
Never open the hood or the side cover while the
engine is turning. Since the rotating parts are
exposed, injury accidents may occur.
⚫
Do not touch the muffler while hot. It may cause
burns.
⚫
After installing the side cover, be sure to
tighten the knob bolts strongly. If the knob
bolts are not tightened sufficiently, they may
detach and fall during transport, causing
accidents.
(2) Tires
The wheelbase can be adjusted by reversing the tires
or adding spacers (optional).
Caution
⚫
Never use spacers other than those provided as
options.
(3) Towing Hooks
[Front of Frame]
[Rear of Frame]
If the machine gets stack in a field, use these hooks to
pull the machine forward/backward. When doing this,
keep the booms at the top positions.
Warning
⚫
Do not use the towing hooks to tow other
machine, etc. It may cause the machine to tip
over.
Caution
⚫
Never pull the towing hooks sideways. The
hooks may detach easily and also cause the
machine to tip over.
Caution
⚫
Never pass ropes, etc., over the boom devices
and pull the ropes. The machine will be
damaged.
Side cover
Hood
Latch position
Knob bolt A
Knob bolt B
