Maruyama Big M M23S, Руководство оператора

Страница: 8 / 64

8
Assembly
Engine and Drive Shaft Assembly
The drive shaft, clutch drum housing and gearcase are
preassembled. Attach the clutch drum housing to the engine
using the four M5 x 20 screws supplied with the unit.
Loop Handle Installation
The loop handle kit contains a package of four screws
and nuts, a rubber sleeve and the bottom clamp for the
loop handle.
1. Slip the rubber sleeve around the shaft,
approximately 9 inches (22.8 cm) from the
end of the stop switch/throttle trigger
assembly, for an initial handle position.
2. Rotate the rubber sleeve so the split is on one side.
3. Place the loop handle and the bottom clamp
over the rubber sleeve.
4. Install the four screws and nuts. Leave the
screws finger tightened.
5. Reposition the loop handle up or down the drive
shaft to the most comfortable position, but no closer
than 9 inches (22.8 cm) from the end of the stop switch.
6. Tighten the screws and nuts.
Connecting the Throttle Cable
1. With the air cleaner cover removed, insert the
throttle cable through the cable-adjuster sleeve
on the carburetor bracket. Make sure the end of
the cable housing is seated positively in the sleeve.
2. Position the slotted fitting on the carburetor so
the recessed hole for the cable lug is away from
the cable-adjuster sleeve.
3. Rotate the carburetor-throttle cam counterclockwise
and slip the throttle cable through the slot in the
slotted fitting, making sure the cable lug drops into
the recessed hole.
4. Operate the throttle trigger a few times to make sure
it works correctly.
SLOTTED FITTING
CABLE LUG RECESSED HOLE
THROTTLE CABLE
LOCK NUT
CABLE ADJUSTER SLEEVE
THROTTLE
CABLE HOUSING
SCREW (4)
NUT (4)
BOTTOM
CLAMP
RUBBER
SLEEVE
LOOPHANDLE
CLUTCH DRUM HOUSING
SHAFT
M5X20
SCREW (4)
ENGINE