[7] ENGINE/ CLUTCH CASE ASSEMBLY
- 8 -
DENGER
Do not run the engine without clutch case
attached, as the clutch could fly off.
1. Assemble the engine onto the clutch case. Make sure the
shaft is fully and correctly up to the shank, then tighten
the four screws A. (Fig. 7-1)
[8] HANDLE GRIP/HANDLE/THROTTLE
WIRE ASSEMBLY
Mounting of handle grip
1.
Double handle
Mount the control handle (A) on the handle (B) and the
grip (C) on the handle (D). Engage individual handles
with the grooves in the handle holder (F), hold them with
the handle holder (E), and fix them with bolts. Fix the
wire/cord Assy to the handle with a band (G). (Fig. 8-1)
2.
Loop handle
The loop handle consists of the loop handle body (A), the
handle holder (B), setting bolts M5
%
30 (C) and nuts
M5 (D).
Set the loop handle body at the marked position on the
drive shaft housing, then attach and tighten the handle
holder (B) with the bolts (C) and nuts (D).
A
Fig.7-1
G
V262W
V282W
A
G
F
C
B
D
E
A
V242W
G
E
Fig.8-
1
B
C
D
F
G
A
C
Fig.8-2
B
Mark
D