7
WALL MOUNTING
If you are not comfortable performing the following mounting procedures, have a professional
perform the installation
(see your Dealer).
FLUSH TO WALL USING KEYHOLES
NOTE: When mounting the MLT-1 center channel, if you run speaker cable down the
face of the wall, apply self-adhesive bumper pads (included) to rear corners of enclosure
to accommodate the cable (see Figure 2).
1. Using #10 screws (not included) screw into the stud. (If model has two key holes,
measure distance apart and use two screws). If you cannot locate a stud, use
appropriate mounting hardware that will hold screws securely
(see your Dealer ).
Do not screw all the way in, head should stand out approximately 3/8 inch (9.5
mm). With the MLT-1 center channel, head should stand out 5/16 inch (8 mm). If
using bumper pads add 1/8 inch (3 mm) to the amount head stands out.
2. Connect speaker cables as outlined in “Speaker Connection” section of this manual.
3. Align keyhole to screw head, and using an “in and down” motion mount speaker to wall.
Fig. 2
