Martin Stage Cyclo, Руководство пользователя

Страница: 12 / 36

12 Stage Cyclo user manual
2. Prepare the power cable and use a screwdriver to clamp the wires in the
appropriate terminals in the insert as shown in Figure 8.
3. Slide the insert and chuck into the housing, making sure that the raised
tabs engage in the keyways inside the housing..
4. Use an open-ended wrench (spanner) to fasten the bushing onto the
housing (max. torque: 2.5 Nm /1.8 ft-lbs).
To plug the power cable in, line up the raised tab on the cable connector
with the keyway in the chassis connector, push the cable connector in and
twist clockwise to lock.
To remove the cable connector, pull back the latch to release the lock, twist
the connector counterclockwise and pull out.
Additional connectors can be obtained from Martin dealers (P/N 05342804)
and Neutrik
®
stockists
C o n n e c t i n g t o a d a t a l i n k
Important! Never connect more than 1 data input and 1 data output.
Fixtures on a serial data link must be daisy-chained in one single line,
maximum 500 meters (1640 ft.) long, with maximum 32 fixtures. To exceed
32 fixtures or 500 meters, or to add branches, use an optically isolated
splitter-amplifier such as the Martin RS-485 Opto-Splitter (P/N 90758060).
A reliable data connection requires suitable cable. Standard microphone
cable is unsuitable. For touring applications, use DMX cable designed for
RS-485 devices. For fixed installations, Category 5 network cable is an
acceptable alternative. Recommended minimum wire sizes are 24 AWG
(0.25mm
2
) for runs up to 300 meters (1000 ft) and 22 AWG (0.32 mm
2)
for
20 mm
[0. 787”]
8 mm
[0. 315”]
N
L
Figure 8: Cable connector wiring
Content in the line drawings on this and the previous page is copyright ©2003 Neutrik
®
AG and
used by permission. These illustrations may not be reproduced in any form without the written
permission of Neutrik
®
AG.