Martin SQC2, Руководство по установке

Страница: 44 / 69

© Martin Engineering GmbH 42 M3682UK-09/17
Troubleshooting
7 Troubleshooting
7.1 Safety information
7.2 Troubleshooting
Check the following items if excessively high wear on the blades
and/or unsatisfactory cleaning performance are/is noticed following
installation:
NOTE
The product is exposed to highly diverse bulk materials and is
often used under extreme operating and environmental conditions.
Malfunctions other than those listed below can therefore occur.
In this case either Martin Engineering or one of its representatives
can assist with the positioning or with special solutions. Do not
start up the conveyor system again until the fault has been
recognised and cleared.
Symptom Cause Remedy
High wear on the
blades. The cleaner is too tightly
tensed on the conveyor belt. Reduce the tension.
Tension values - see fig. 22,
page 28
Insufficient cleaning
performance and
material
accumulation. The cleaner is not tensed
enough or is tensed too
tightly on the conveyor belt. Increase or reduce the tension.
The blades are worn. Inspect the blades and replace if
necessary (see “Weekly
maintenance”).
Unusual pattern of
wear or damage to
the blade. Damaged conveyor belt or
connection points. Inspect the conveyor belt's
connection points and repair or
replace as needed.
Cleaner installed in the
material flow. Install the pre-cleaner in a different
place.
Different tension values of
the In-line-Reversing
tensioner. Check the tension values and
possibly re-tighten.
Noises or vibrations. Cleaner on the conveyor
belt too loose or too tightly
tensed. Correct the tension if necessary.
Blade not correctly aligned
with the conveyor belt. Align blade - see fig. 13 on page
22.
Tab. 11: Troubleshooting