Martin RoboScan Pro 518, Руководство пользователя

Страница: 7 / 24

7 Installation
I n s t a l l i n g a P l u g o n t h e P o w e r C o r d
W A R N I N G !
For safe operation, the fixture must be grounded (earthed).
The RoboScan Pro 518 may be delivered without a plug on the power cord. Following the
manufacturer’s instructions, install an approved 3-prong grounding-type plug that fits your
supply. Connect the wires to the pins as listed below. If the pins are not clearly identified, or
if you have any doubts ab/out proper installation, consult a qualified electrician.
R e l e a s i n g t h e P a n / T i l t L o c k
The pan/tilt assembly floats in a rubber mount in order to reduce noise. To protect the
assembly from damage during shipment, it is locked with plastic straps and 2 thumbscrews.
These must be removed before using the RoboScan!
1. Cut and remove the 2 plastic straps.
2. Remove the thumbscrews from positions A1 and A2 on either side of the
pan/tilt assembly and store them in positions B1 and B2.
Note: It is strongly recommended that the pan/tilt assembly be locked for transportation by
replacing the thumbscrews in positions A1 and A2.
3. Carefully remove the protection foil and warning notice from the mirror.
R i g g i n g
1. Secure the mounting bracket to the 3 bolts located on the top of the chassis
with 3 M8 self-locking nuts (included).
2. Verify that the clamp (not included) is undamaged and can bear at least
10 times the fixture’s weight. Bolt the clamp securely to the bracket with a
grade 8.8 (minimum) M10 bolt and lock nut, or as recommended by the
clamp manufacturer, through the 11 mm hole in the center of the mount-
ing bracket.
3. If permanently installing the fixture, verify that the hardware (not
included) and mounting surface can bear at least 10 times the fixture’s
weight.
Wire Pin Marking Screw color (US)
brown live “L” yellow or brass
blue neutral “N” silver
yellow/green ground green