Martin RoboScan Pro 518, Руководство пользователя

Страница: 10 / 24

10 RoboScan Pro 518
s e c t i o n 3
O P E R A T I O N
S t a n d - A l o n e O p e r a t i o n
The Roboscan Pro 518 may be operated without a controller in stand-alone mode. In this
mode, the fixture performs a random sequence that is triggered by the beat of the music or at
a set speed. The DIP-switch must be set to the desired stand-alone mode before applying
power.
1. With the fixture powered off, set the DIP-switch as shown below for the
desired mode.
Pins not listed must be switched off.
2. Apply power to the RoboScan Pro 518 to run the sequence.
C o n t r o l l e r O p e r a t i o n
G e t t i n g S t a r t e d
The RoboScan Pro 518 may be used with DMX-512 and Martin protocol controllers; it
automatically determines which protocol is used. Protocol auto-detection can be reactivated
if necessary by switching on all ten DIP-switches and then resetting the address.
1. Connect the RoboScan Pro 518 to the controller as described under “Setup
for Controller Operation” on page 8.
2. Switch on and configure the controller.
3. Apply power to the RoboScan. After a short reset procedure it will
respond to the controller.
Stand-Alone Modes
Description Pins Switched ON
Random sequence, wide pan/tilt, auto trigger 2, 10
Random sequence, wide pan/tilt, music trigger 1, 2, 10
Random sequence, narrow pan/tilt, auto trigger 2, 3, 10
Random sequence, narrow pan/tilt, music trigger 1, 2, 3, 10
Lamp ON 8, 10
Lamp OFF 7, 10
Adjustment sequence (for service use only) (1), 5, 10
Adjustment sequence (for service use only) (1), 2, 5, 10
L.E.D. chase auto-trig (for service use only) 4, 10
L.E.D. chase music-trig (for service use only) 1, 4, 10