Martin Magnum Pro 2000, Руководство пользователя

Страница: 9 / 12

Operation 9
4 To terminate the auto-timer sequence, press the timer store button for 5
seconds. This clears the memory.
For example, to program 15 seconds of smoke every 2 minutes, press the smoke
button for 15 seconds, wait 1 minute and 45 seconds, and then press timer store.
0 - 1 0 V O P E R A T I O N
Operation via a 0-10 volt signal is similar to operation via the remote control unit.
Unplug the remote control unit and connect your analog source to the XLR control
input inside the control unit well. Verify that GND (ground) on your analog source
connects to pin 1 on the XLR control input and that the +0-10V output connects to
pin 3.
The analog control levels are shown below.
M U L T I P L E M A C H I N E S
Whether you operate your Magnum 2000 via the control unit or a 0-10 volt
source, you can command additional machines through the XLR “slave output” on
the back panel. Connect the slave output on the first machine to the control input
(located inside the control unit well) of the next machine. Continue by similarly
connecting as many machines as desired output to input.
All machines connected in this manner will produce smoke at the same time and
output level as the first machine.
Voltage Function
0 - 1.0 V Standby
1.0 - 2.5 V Heater power on
2.5 - 9.5 V Smoke emission, increases with voltage
9.5 - 10.0 V Timer store