Control
settings
15
Setting the DMX bas e ad dress
Use the Previous / Next buttons to select the
option.
Use the Up/Down buttons to set the DMX base address from
to
. If
you hold down the button the address will count up or down.
Press the Enter button to store the address setting.
The machine will automatically respond to a DMX controller whenever it is
connected.
When using in a DMX system ensure the LINK menu is set to RECV (the default
setting) to avoid causing DMX errors to other devices on the system.
Setting the master -slav e link mod e
It is possible to control several machines from one digital remote. The machine
with the remote plugged into it becomes the Master. The other machines are
Slaves. The machines are interconnected with DMX cabling.
Use the Previous / Next buttons to select the
option.
Use the Up/Down buttons to select
(slave unit) or
(master unit).
Press the Enter button to store the link setting.
The machine should be set to
only if it is running as a master. If running
as a slave, stand-alone or DMX controlled it should be set to
.
Aux option
This option is not currently used and has no effect on the machine.
PSI o pti on
This option is for service use oniy.
Priming th e machin e after fluid o ut
If the machine runs out of fluid it should be shut down to prevent damage to the
pump. To suck the new fluid back into the machine, replace/refill the fluid tank
and use the prime function.
Use the Previous / Next buttons to select the
option.
Use the Up/Down buttons to change the option to
.
Press the Enter button to start the priming function.
The machine will pump at full power for about 10 seconds or until the unit senses
fluid in the heat exchanger.
To exit this menu if you decide not to activate the Prime function, select
and
press Enter.
If the machine is not up to operating temperature the Prime function will do
nothing.
Res etti ng options to factory setti ngs
The factory settings configure a standard mode of operation for the machine.
Use the Previous / Next buttons to select the
option.