12
Installation and setting up
Before connecting the haze machine to power, verify that the AC supply is
adequately dimensioned for the current draw of the machine. The machine
requires:
3.1A @ 230V (EU model)
6A @ 120V (US model)
Check that the local AC voltage is appropriate, as indicated on the machine’s
serial number label. If your AC voltage is outside the appropriate range, do not
use the machine. Contact Martin Service for assistance.
Setting up
Fill the fluid tank only with Martin C-Plus Haze Fluid™ (see page 21).
If DMX control is being used, connect the machine to the DMX line (see page
18). If the Jem Digital Remote is being used (optional accessory), connect the
remote to the Remote socket (see page 9).
Final ch ecks
Before applying power to the haze machine, verify the following:
•
the machine is safely located or installed and meets the location
requirements stated on page 11
•
the operator is familiar with, and able to comply with, the requirements
for safe operation listed on page 5.
•
the haze fluid is one of the genuine Martin fluids listed under “Haze fluid
options” on page 21.
•
the machine is electrically grounded (earthed)
•
the AC power distribution circuits and lines are adequately rated for the
current load
Tur ni ng on th e power
Turn on the main power switch located next to the power inlet. The display will
show HEAT. If the display shows OFF press the RUN button (bottom right hand
button) on the digital control panel. The machine will remember its state from
when it was turned off last time, so it will only power up in OFF mode if you have
previously disabled the heaters.
After about 6-8 minutes the display should show CONT and the machine will
begin producing haze. If the display shows RDY press the RUN button to start
haze.
Tur ni ng off th e power
The Hazer Pro is designed to run a self-cleaning cycle on power down to help
prevent blockages, using its built in rechargeable battery. When you turn off the
power the cleaning cycle will begin automatically if required.
If cleaning is needed, the display will show “WAIT”, then “90” counting down to
“00”. During this time the unit purges the fluid from its internal pipework to help
prevent blockages.
The machine will then power off automatically.
